radiator. Follow that hose toward the engine until you find the elbow piece where the hose meets the engine. If you remove that elbow piece, you'll see the thermostat in the "hose line," If this solve
...remove an airlock in the radiator? Its not possible to get an air lock in the radiator when the vehicle is running the water pump is always pumping antifreeze through it any air comes to the topand ...
remove the radiator cap start the car you will have less pressure with it running or you can do this with it not running. You need to push down on the cap and release it from the notch lock then still
...radiator cap? Sometimes on a cool engine, I remove the thermostat, hook everything up, make sure coolant is full. The coolant flow is instant when you crank or start it because you don't have to wait ...
...Remove the radiator inlet hose from the thermostat housing. Remove the thermostat housing bolts. Remove the thermostat. Clean and inspect the thermostat housing gasket mating surfaces. To install: ...
...radiator start by draining the rad.remove hoses top and bottom if automatic remove the transmission lines then undo bolts that hold rad. in frame then reinstall new one in reverse good luck also put ...
...remove the radiator from a2008 Chevy Uplander ...
Question about 2007 Uplander
replacing radiator support on 2007 uplander. how do I remove the front bumper surround
Question about 2007 Uplander
Can I replace the drain petcock on my Chevy Uplander without removing the radiator? Should be able to if your hand can fit in that area .
...Remove the old radiator. There are usually bolts or brackets that secure the radiator in place. Remove these, and then gently lift the old radiator out of the engine compartment. Install the new ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
