Questions & Answers for: remove radiator 2005 chevrolet impala

...Remove one of the bolts from each of the upper engine mounts. The mounts are shaped like a Y and are attached to the radiator support. Jack the engine up a little, and it should "roll" forward and ...

...remove the radiator cap, if you have one, if not remove the resevoir cap. start the car and let it warm up to operating temperture. keep check on the level and fill as necessary. you may have to do ...

...radiator hose to the back of the engine. Remove the two bolts at the end of the hose and the thermostat is inside. Note the engine is sideways in the car so the back of the motor is really on the ...

...remove by pulling them staright forward. Now you can access the headlamp bulbs and turn signals. Don't be confused by the radiator... I was working on a different project. This is my 2002 Impala LS. ...

...impala its under the alternator which has to be removed the radiator tank  resevoir, the inlet for the heater hoses which is on the front of the motor  also has to be removed to get all psp ...

radiaror drain plug location They are at bottom inside on right or left,some are in a super tight fit,need a pair of plyiers,or you can just remove bottom radiator hose to drain.

where is the radiator petcock located on a2004 impala The petcock is located on the drivers side of the radiator and is easily removed with a 18mm socket

...radiator in a container. Remove the engine end of the top radiator hose. The housing has 2 bolts that you remove. Remove the thermostat and clean the surfaces and reinstall the thermostat. Reinstall ...

...radiator in a container. Remove the engine end of the top radiator hose. The housing has 2 bolts that you remove. Remove the thermostat and clean the surfaces and reinstall the thermostat. Reinstall ...

...radiator ( closest to engine ) Remove the coolant pressure cap. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information. Place a drain pan under the drain ****. ...