...pressure washer that drips oil from the under carraige of the honda 4.5 hp engine. What do I need to fix this problem If it is a vertical shaft engine then it is most likely the crankshaft seal. That ...
pressure seems to be at about half or less of what it was. I've tried different nozzles, etc. I'm not sure if this could possibly be related, but the Honda engine only runs smoothly when it is at half
pressure washer with a 5.5 honda engine. No high pressure, hose pulsates as does water out of the outlet. have removed the unloader valve twice and cleaned it to no avail i had this same problem on my
...pressure washer manual pw2hp I have no manual and cannot find where to put oil in? The engine appears to have seized. It is the first time I have used it and it states aordinary unleaded petrol. hi ...
Question about Maxus Prosumer MX5223 Pressure Washer
...remove the 4gpm pump on my pressure washer. I want to replace the 4gpm pump on my North Star pressure washer 11 Honda gx340 engine. I can't figure out how to get the pump off. took out four bolts and ...
...be a vented plug ? HI your machine would have been delivered with a blanking plug in the pump. You will need to remove this and fit a vented pump or your pump will build up too much pressure
Question about BXD2527 Pressure Washer Pump
...pressure comes out of pump. Next, remove water hose and look at filter washer. Clean or replace filter washer. Turn on water and it should come out of pump on other side. These steps will tell you if ...
Question about Honda GCV160 Engine
...pressure washer 2600 psi 2.3gpm Engine seems to run well but pressure started momentary losses. Frequency and length of pressure loss has increased unacceptably. When nozzle is removed, flo GCV 160 ...
...pressure washer ? you need to remove the pump then the end cover from the engine remove the cylinder head the unbolt the connecting rod push out the piston hone cylinder and then wash the motor out ...
Question about Maxus Pressure Washer MX5222
...remove and clean this valve or you may want to replace the valve with a new one.If you take the high pressure hose off of the pump and with the water turned on you can start the engine each time then ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions