Questions & Answers for: remove power steering pulley v8

remove 2 bolts just lift the fans out. then you will see a tensioner i think it has 3/8 drive square hole in it( could be 1/2'' drive) just pull it down with a long bar with a 3/8 end on it to release

...to remove the power steering pump. Do I have to take the power steering pump off to remove the timing chain cover? If so, how? Have you removed the PS pump pulley? You need to do that to get it

...Remove A/C compressor/power steering pump bracket and accessories to clear water pump stud bolt. Remove water pump attaching bolts and the water pump. INSTALLATION Reverse procedure to install. ...

power steering pump a pain as well. I know that one needs a special puller to remove and put on the pulley. I have a 2002 Escape V6 w/ 100,000 miles and I just changed the plugs. If you have a V6, you

power steering hose, and I've run both of them for 8 years or so with just the high speed sensor cooling things down. When the water pump went bad in one of them 2 years ago at 160,000 miles, I put in

...Remove the power steering pressure hose (3A719) by unscrewing connector from the pump. On the Aerostar 3.0L V-6 engine (6007), loosen the drive belt tensioner (6B209) and adjustment bolts. Item Part ...

...power steering pump noise, you can try checking the fluid level to see if its low, this is a problem with lincoln and ford the pumps get noisey,a flush of the system helps sometimes,also remove the ...

...power steering,smog pump,you can rule out a few by checking there rotation, and if all are good you have a severely overheating engine with no thermostat in it check your coolant color green or gold ...