Question about Poulan/Weed Eater #Wt200 711724 24cc Gas Blower/Vac
...Remove limiter caps. Turn both jets a 1/2 turn counter clockwise, Start, then fine tune. Use the low speed and idle screws to smooth out low to idle speed and the hi speed jet to tune the full ...
...Remove the plastic cap and unthread the adjusting worm nut. The cable end "ball" will come out with the help of needle nose pliers also. Pull the cable slack up to rotate the "ball" out of the ...
...Remove and clean the drain screw and area. Inspect bowl gasket and replace if necessary. Clean and inspect overflow pipes and tubes, look for vertical cracks. Floats: There are several types of float ...
...remove diaphragms and gaskets, soak carburator in carb cleaner over night, then spray dry. put back together with new diaphragms and gaskets. Triky part is next H-red ( high) L-white (Low) adjusting ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions
