Questions & Answers for: remove old intermatic timer

old timer A was used in the hook up So I am confused from left to right in the box which wire should go where So much for my attempt to be an electrician but I do know to shut the power completley off

...old and is sporadic when it comes to coming on and staying on. I keep resetting the timer but to no avail. I would like to replace it but do not have the manual. What do I need to do to remove the ...

...Intermatic timer, then timer needs to be replaced. Make sure you have electricity. And be sure to mark your wires before removing timer. Mark the black wire that connected to timer-black wire. It's ...

...remove old clock motor. Reattach white wires on terminals 1 and A, tighten screws very tight. Reset current time: lift and rotate dial until current time lines up with silver pointer. Grainger sells ...

...Remove clock motor with star screwdriver tip Connect new clock motor wires to DIFFERENT terminals than before. Old clock was connected to terminals 1 and 3 New 120V clock motor is connected to ...

...TIMER SWITCH SO YOU CAN REMOVE THE SWITCH PLATE. The knob pulls off. Use a screwdriver or fingernail file to pry up. Some really old timers, the knob attaches with a tiny screw located on the

...Old 4" goes to new X T104 Intermatic timer is SPDT single pull double throw, so it turns off both wires going to Load. New L1X2 timer is SPST single pull single throw, so it turns off one wire going ...

...remove timer mechanism using thumb spring located top inside box. If override lever does not function correctly, then timer mechanism needs to be replaced. Usually it's cheaper to buy whole timer ...

...old model WG230-6. Can I use the new timer as the replacement? The Intermatic E1020C timer is a 120 volt, single gang, single pole switch.  This means it must ONLY be used on 120 volt circuits ...

...remove the plate, please be advice. 10-22-12FF30 Intermatic timer: The turning knob pulls off.(With some really old models, 1960s, there is a small set screw on the fat end of knob.)Under the knob is ...