Question about 2005 Cobalt
...blocked by anything else, then you don't have to remove the engine. Come to think of it, I don't think that I have ever seen a car where you had to remove the engine in order to remove the oil
...remove the trans pan (12 bolts I think), inside you will find the filter replace it, after u finish refill with the exact same amount of fluid (about 3-4 quarts of Dexron 6 ATF) and then recheck hot, ...
...pan bolt torque specs also oil clearance for rod journals if you just go to a mecanic and ask what are the specks on that they should know but i think if you just tighten them down with an impact ...
...oil pan on a 2007 chevy cobalt? I have removed all the bolts that secure the oil pan, but it will not come off. There is a gasket between the engine and the oil pan. It is probably stuck. You will ...
Question about 2006 Cobalt SS
...oil pan from a 2.2 l chevy motor fit on a 2.0 l chevy motor? broke the oil pan hard to find one can the oil pan from an earlier ecotech like a 2.2l on a caviliar 2002 or 2003 fix this issue There are ...
Question about 2006 Cobalt LTZ
...oil pan. My car slowed down so i pulled over and shut it mdown. Id thers iny major problems i should be concerned with or will a new oil pan fix it all up? If u still have oil in the oil filter, the ...
Remove the oil pan bolts from only the front and the sides. 4. Loosen the rear oil pan bolts about 4 turns. 5. Lightly tap the oil pan with a rubber mallet or pry in order to allow the fluid to drain.
remove oil pan chevy 2006 hhr e silicona g how remove the oil pan chevy hhr 2006 for change the silicona gasket Auto Talk site online type in question start with oil pan removal.also ck youtube videos
...remove the oil pan in a 2005 Chevy equinox Frame is in the way of taking it off How do i remove the oil pan on a 2005 chevrolet cobalt Before servicing the vehicle, refer to the Precautions Section. ...
Question about 2006 Cobalt LS
2006 ls Chevy cobalt can I repair a cracked oil pan with epoxy dont wanna go through taking the pan off it wont work. period. best bet is to get it brazed after emptying it of oil
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions