Questions & Answers for: remove motor oster blender

...motor did not burn out and perhaps it is just the fuse. I took the bottom off of the blender and found the fuse burned out. I would like to replace the fuse but I do not know how to replace it. I can ...

Remove the motor and unscrew the old coupling. Mine had not been replaced since my grandmother bought this blender who knows when, so the coupling was really stuck. I did not have a tool narrow enough

...motor assembly. Remove the 3 screws from the top of the gear box pry the box open,remove the gear with the piece that needs to be replaced,now you need to get the piece unscrewed from the gear.I did ...

...oster snapped in half. I have the replacement part already I just cannot figure out how to get the broken coupling off the base of the motor. I also got a replacement square drive and slinger because ...

...drive removal How do I remove (in order to replace) the rubber drive gear (attached to the motor) which drives the rubber gear attached to the blade in the pitcher top? plz cont -23051554 \ ...

Remove the motor housing from the blender (mine was loose from removing the two screws earlier). 3. Remove the fan by removing the fan nut. 4. Take apart the motor housing. Mine had two machine screws

remove the base of the blender (using a 1/4" socket wrench or nut driver inside the four rubber feet), you should see the big metal fan covering a big motor assembly. The fan is screwed on one side of

...remove motor Hold washer w/ vice grips and turn stud counter clockwise with box end wrench, small crescent wrench, or another vice grip. Should turn fairly easily at first then finger loosen. A 50y/o ...

...the motor does not have enough torque.. You need to remove the blade assembly and completely clean out the bearing and reassemble after the Mr. clean operation. A lite dab of oil is also called

...Oster blender is probably around 25 years old but still works. I stuck the blade on the base without the jar on because I was cleaning the jar. (You aren't supposed to do this for safety reasons, by ...