Questions & Answers for: remove kenwood cd player faceplate

Kenwood KDC-X717, and when the vehicle is powered on, the faceplate opens and stays there. There is no display at all. When I pull off the faceplate, the unit closes back up, until I put the faceplate

kenwood deck wont open if you have checked all of your wiring and fuses and already tried hitting the reset button you should first remove the faceplate and check the contacts on the main unit and the

...Kenwood wont open, everything plays, but cant eject disc, if you have already tried hitting the reset button you should first remove the faceplate and check the contacts on the main unit and the back ...

Kenwood KDC-W5534U and the display on the flip down faceplate doesn't light up all of a sudden. I can still use the controls, ie CD player, radio, but can't see what I am displaying. Have I turned off

...reset itself. make sure there is no dirt between the metal connections. on my kenwood, excessive removal of the faceplate caused a little dirt build up...check this and itll probably solve your ...

...kenwood KDC-V7017 player and have been trying to remove the faceplate because there hasnt been a display on the screen. i press the SRC button like it says in the manual but all it does is make a ...

...kenwood i am unable to remove the faceplate or eject cd on a kenwood KDC-516S CD Player that came with a car i purchased. it did not come with the remote or instruction booklet. i dont think the ...

...remove the faceplate but there is no display? you probably have a bad flexible cable (goes from the face to the main motherboard). unless you are good at desoldering and soldering, you may want to ...

CD eject position. If I remove the faceplate the mechanism rotates to the position where the controls would be visible but when I attach the faceplate it rotates to the CD eject position again, but no

KDC-v7017. Batt was recently removed and reconnected. Faceplate goes to the neutral position, for removing the faceplate. Removed it.The mechanicals then reset it self to the flat mode. I reinstalled ...