Question about C1000 Espresso & Coffee Maker
...Jura Capresso units are actually oval security screws. The bit that removes these screws are made of a very hard metal and cost me over $50.00 two years ago. Also many people who attempt there own ...
...oval end of the screw. After clamping it tightly, I used an adjustable wrench to turn the vice grip and the screw to successfully remove them. I replaced them with normal Phillips screws during the ...
Question about Impressa Z5 Espresso/Coffee Maker
...remove the Jura crest by turning it clock wise. I use a piece of ruber pressed against it to help. Then you will need a special screwdriver for the oval shaped screw heads. I ordered the screwdriver ...
Question about Impressa F9 Espresso Machine
...remove the 4 oval screws on the back panel, then lift up the top panel. Then take a good grip in the left panel (seen from behind) and pull back. The other panel you use your fist and hit lightly ...
Question about C3000 Espresso & Coffee Maker
...remove the back to see what the problem is I sent the machine in for repairs once and now have the same problem all over again, please help There are to oval screws on the backpanel. After removing ...
Question about C3000 Espresso & Coffee Maker
...remove the waste tray. On the Jura F90 use pliers to undo two oval headed screws at the back at the top. You'll be able to remove the top panel after using a pry tool to disconnect two lugs at the ...
...Jura special oval screws (I don't have the tool). Is there any other way to fix this problem? I believe once I remove the back panel and clean out the grinder and the dispenser it would be fine??? ...
Question about Impressa X7 Espresso Machine
jura impressa x7 has a malfuction 8 error. what is it and how do I fix it? In my case the brew group is jammed in the down position - so I could not remove the grounds bucket. I think error 8 may be ...
Question about Impressa S9 Coffee Maker/Espresso Machine
remove the security screw. 9. The thermo sensor connects to the electronic board. Detach the wire from the electronic board. Now the thermo sensor is off. 10. Replace the thermo sensor with a new jura
Question about Impressa S9 Coffee Maker/Espresso Machine
Jura Z5. Choosing cappucino the milk froth comes normally but coffee comes from espresso nozzles. What is the failure and how it will be repaired? The draining water comes from cappucino nozzle. ...
Usually answered in minutes!
1,392 Questions
801 Questions
725 Questions
572 Questions
453 Questions