Questions & Answers for: remove front seats 2000 toyota

2000, and how easy is it to replace Yes, remove the rear seat cusion and then lift up the padding. Take the screws out of the cover and them you can access the top of the fuel tank and remove the pump

...remove my front fenders for my 2000 Toyota Celica GTS? take the inner fender well out, unbolt the fender from the bumper, take the 2 bolts out under the car at the fender, lastly take all the bolts ...

2000 Celica GT-S with about 126,000 miles. Thank you It sounds like you have a broken lift bolt, do you have a Toyota Celica GTS? If so look at this: http://www.celicahobby.com/tech/tsb2/TSB_liftbolts

...2000 Celica GT driver door lock is acting up; it sometimes will lock when I press my alarm remote, sometimes it won't. it could be the door lock acuator going bad it could have a intermittent short i ...

...toyota celica? I have taken apart the trunk to get to the bolts and once I have taken disconnected the strut there doesn't seem to be enough room to get the old strut out... do i need to remove the ...

...the vehicle, driver's side, right in front of your left knee if sitting in the seat. Remove small cover to access. The second is under the hood behind the battery. 3 metal clips hold the lid

2000 Celica back seats bottom stay wet all the time. I removed the seats and they are soaked with water. Where is it coming from. Thanks for any help. If the car has a sunroof, your sunroof drains are

2000 Toyota Celica GT with 117,000 miles making revving noise I have a 2000 Toyota Celica GT with 117,000 miles. I am starting to notice a slight revving noise in my engine and does not always happen ...

...2000 toyota celica gt backs seats are always wet why i would have friends ride in my car and sit in the back seat and they complained theyre pants are wet everytime they sit down. what could be the ...

...remove harmonic balancer on my 2000 toyota celica gt 1.8l you need to loosen the alternator to get the belt off then undo the bolt on the harmonic balancer. If you can't remove the harmonic balancer ...