Questions & Answers for: remove front panel haier air

...remove filter and front cover 2 screws side 2 under filter. Do coils look cruddy ok, sprayed my coils with "gunk engine cleaner" with unit on side so electrics were up and rinsed with thumb over hose ...

...remove the "E1" code from the display, and plug it back in and re-start it, it will simply run for anywhere from a few minutes to a few hours, and then merrily shut down again with the same flashing ...

...remove the front plastic housing of the unit to clean inside of it. When I did, I accidentally broke one of the very small wires from the swire harness that does from under the push-button control ...

...Remove the front cover's 2 bottom screws and lift up and off the front. Remove the left side 3 screws and the rear panel 4 screws and this gave me enough play to prop up the left side panel to get to ...

remove the entire front panel of the unit, you can access everything you need to clean, check and lubricate. This is also how you access the air intake filter for cleaning. The front just pulls off as

...front panel, turned it over and removed the 4 screws from the back of the control pad (not the six screws on the outer perimeter). I looked for a stuck button but did not find one. I just pushed all ...

...filter.. where is it as you look thru the front panel you should see a spong like filter. remove the front panel to access it. wash in warm soapy water and replace it . should be done monthly at

...front panel, turn it over and remove the 4 screws from the back of the control pad (not the six screws on the outer perimeter). look for a stuck button. If you but don't find one, just push all ...

...remove the front and back panels, vacuum thoroughly, wipe down the insides and reassemble and it works like new again. It is unreasonable for things like this or fans to be expected to run for years ...

front panel on Haier window unit Have removed the 2 visable screws at bottom each side, but am meeting with much resistance when attempting to pull off. bottom pulls away,but not top. It's all plastic