...exhaust manifold after engine warms up. These 3.0 engines had an issue with the manifolds warping and shearing off the manifold studs particularily on the corners. To repair correctly you would need ...
...manifold, the exhaust gas gets sucked into the air intake. You can put the heater in recirc mode and it will draw air in from inside the car instead of though the outside air intake. You can't leave ...
...are leaking antifreeze, so I nedd to know how to get to them to take them out and put new ones on. what parts do I need to move to get to them? remove exhaust manifold ( problems with bolts braking ...
1998 it is buried under the intake manifold. But ignore the knock sensor code, it means absolutely nothing. It will not resolve any issue you have. The KS code is usually the result of a broken engine
...exhaust gas recirculating valve, located on the intake manifold. Unbolt is, clean it out with a wire brush and carb cleaner, refit. Get the Nissan checked again, if it is still high, the catalytic ...
...3.3 engine. I need exhaust manifold ft.lb tighten with a 3/*8 drive rachet and that will be enough ,small grunt when pulling on the rachet and you will have the correct torque .about 35 ...
where is located the knock sensor on my 1994 nissan quest The knock Sensor is located under hood, center, front engine area, mounted on lower engine block below exhaust manifold.
-MAF/VAF sensor---fuel pressure/pump---injector/s -- HO2s .==check the flexible section of the exhaust at the manifold for cracks -check the hos2 sensor==have a pressure test done on the fuel manifold
...exhaust manifold bolts what is the torque spec. for exhaust manifold bolts Looks like about 21-35 ft. lbs. depending on which engine u have. ...
...exhaust manifold before the catalytic converters and two in the exhaust pipes after the catalytic converters. Always post a year, make, model and engine size to help us get you the best info we
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions