Questions & Answers for: remove engine 2002 mercury sable

engine? You must remove the transmmission. then if you can make enough room by releasing the motor mounts and placing two by fours under them you'll be able to gain acess to drop the oil pan. Drain it

...engine coolant reservoir i have cracked coolant jug needs to be replace just need to know how to remove old one by myself that is so easy unhooked connector plug,unhook hose,loosen three bolts take ...

how do i change the rear spark plugs on the v6 3.0 liter dohc engine? You will have to remove the intake to be able to get to it to change the plugs.

...engine block.Remove the support bracket. Remove the nuts.Remove the bolts.Remove the bracket.Remove the crankshaft position (CKP) sensor. Disconnect the electrical connector.Remove the bolt and the ...

how to replace transmition do you have to take out A frame bolts The proper way to do it is by supporting the engine and removing the subframe assembly.

get to the camshaft Once you get the engine cover off you should be able to see the cam cover itself. You need to remove the bolts on top of it. Once removed you should be able to access the camshafts

...engine is cool and remove the air filter and housing under hood on drivers side. This makes a "tunnel" to run your arm from back of engine towards the front along plug wires. The plugs are easier to ...

...remove the leads from the battery and clean then if dirty or else you can tighten the leads and the connection of the ground( negative) to the car chassis.If the fault stays ONLYwhen ...

...light, how do I reset the codes so that the engine will pass state emission inspection. Just have to fully remove the battery for 30+ minutes and the memory will be cleared. And your MAF is ...

an engine support to hold motor in place, disconnect anything that is attached to sub frame, ex: motor mounts. then unbolt sub frame bolts(4) and raise car to remove sub frame. note sub frame is heavy