Question about 1998 Ranger SuperCab
...door latch with WD40 or silicone lubricant. You might have to remove or partically remove the plastic shield cover the opening. It's the part the door latches too, spray all around inside there and ...
Question about 1998 Ranger SuperCab
...remove In-cab dome light fuse because door ajar light would not go off. Can that be a factor? Also my AC compressor kicks on and off even when AC, Defrost Mode, or Fan is NOT in use. Can that be a ...
...door closes rather than the other way around which would be a better design. A work around is to simply remove the dome light fuse until you can get the switches working. I had the same problem with ...
Question about 2000 F250 Super Duty Crew Cabs
...door ajar/dome light to go out How do I get the 'door ajar'/dome light to go out. Most of the time, problem occurs with the key in ignition, occassionally problem occurs with key out of the ignition. ...
...remove the door panel and the rear glass run channel, most likely the drivers door is the one that is defective since it sees the most use, they are a real pain to get out,they twist in and the old ...
...remove the switches spray with wd40 any other faults would be obvious once you have removed it. there is one on each door including the boot although the boot / trunk will normally be seperate. Hope ...
Question about 1999 Ranger SuperCab
...Remove the center instrument panel finish panel. Disconnect electrical connectors. Module Controlled Functions The multifunction modules consist of the following: generic electronic module (GEM) ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions