Question about 1992 Bonneville
...remove ignition and dimmer switches. Refer to Fig. 6 to disconnect dimmer switch from bulkhead connector. When installing dimmer switch, depress switch slightly to install a 3/32 inch twist drill. ...
...dimmer switch which is near the bottom of the steering column, u will need to remove the trim under the steering column and then the must remove the 2 nuts that hold the column to the bottom of dash, ...
Question about Ceiling Fan Light Switch Control
...Remove black vented dimmer assembly by removing wire nuts and disconnecting the 2wire connector(black and white wires). Cut the 2wire connector off and save it in case you find a part someday. Wire ...
Question about Ceiling Fan Light Switch Control
remove the dimmer and replace it with a toggle switch Get a switch at the hardware store or at the big box place. You only need a standard wall toggle switch - color to suit your taste ... gray, ivory
...the dimmed light on and off? You will need to replace it with another 3-way dimmer. Here is a link to an excellent how-to write-up. ...
...switch or dimmer, fins must be removed to allow the switch to physically fit. If any fins are removed, the rating of the switch is reduced. Page 30 of the manual shows that a 600w strap ...
Question about Decora Light Dimmer Switch
dimmer. next remove cover and screws. then remove mounting screws. loosen screws holding wires. if one is loose tighten and retry dimmer and don't forget to shut power off after trying dimmer. replace
...remove dimmer switch and replace with new one. Probably all rusted and corroded inside, you may have blow the brake switch when you hit the dimmer, also check the wiring to both the dimmer and the ...
Question about 1975 Eldorado
...Remove the dimmer switch. Remove the screws. Remove the dimmer switch. Installation NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle ...
Question about 1975 Eldorado
...the old dimmer switch under same wall plate. There's 2 white wires and 1 blk wire once old dimmer removed. No ground wire. Is original a 3-way dimmer (2 or more switches control same light
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions