Question about 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
...bissell.com.au/images/IncludeContent/Service_Center_Help/Upright_Deep_Cleaner_Repair_Guide.pdf dont replace the whole pump just the red thing When removing the six screws on the black cover that ...
cover, then turn it over, remove the screw holding the red lock and pull the cap and brush roll out, remove the cap, remove the cogged belt, then you can put the new pump belt thru that slot, put over
Question about Lift-Off(R) Revolution(R) Turbo Upright Vacuum
...cover off, it is on the left side on top of the noozle. Then turn it over, take out the one screw from the red lock, pull it off, then remove the cogged belt, take out the old pump belt if still on ...
Question about Lift-Off(R) Revolution(R) Turbo Upright Vacuum
...Bissell Pro Heat 2x steam cleaner. The belts both appear to be okay, yet the brushes won't rotate. Is there anything else I can try to see if I can fix it? Must likely the brush motor is bad. The top ...
cover, then turn it over, remove the screw holding the red lock and pull the cap and brush roll out, remove the cap, remove the cogged belt, then you can put the new pump belt thru that slot, put over
...remove to take off the top, before removing the top, turn the smart mix valve to about the half way point so the piston won't fall off. When you are ready to re-install the top cover, just before ...
Question about 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum
...remove cover with cellphone take pic of vac with cover off [ for reference on reassembly] water head located on the front of vac pull head and hose from seat wash with hottest water you can stand try ...
Question about 1699 ProHeat Clear View Upright Steam Vacuum
...cover removal How do i remove the clear plastic cover on my carpet cleaner to clean the dirt out of it? I removed the two screws near the head but I can't get the cover off just lift it up probably ...
Question about 8910 ProHeat Clear View Upright Vacuum
remove the 4 screws on each side using a Philips screw drive set the screws and the brush cover aside. - pull brush straight out and you will see the gray rubber band. -replace the new drive belt over
Question about 25A3 Proheat Upright Deep Heated Cleaner Chemicals Included
Remove the cover from the heater making sure you don't lose the little gaskets on each screw. Clean the channels inside the heater and put the cover back on. Be aware of how you are Taking it apart so
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions
