Questions & Answers for: Jeep Wrangler remove cover

Removing seat covers on 2000 Jeep Wrangler Sahara How do I get the seat covers off? They appear to be tacked down to the padding with a thin metal wire. The seat covers are held on by "hog rings" They

...remove the piece of wood. Install the flywheel and torque converter access cover. Install starter motor. Connect the exhaust pipe to the hanger and to exhaust manifold. Install the transmission oil ...

...cover and remove the cover. Remove the the instrument cluster (it pulls straight out toward you) and make sure the wires are not corroded. Make sure the wiring harness is firmly attached to the metal ...

remove the cover pieces where the guages are, the four in the middle, there are 4 screws 2 on the top and 2 on the bottom. once you remove those pull off the guage cover off, then there are 2-4 screws

...remove the panel and you will find a plastic cover that cover needs to be removed to access the window regulator. once there you will see screws which hold the window those need to be removed so that ...

...cover. Remove the A/C compressor, if equipped, and alternator bracket from the cylinder head and move to one side. Remove the oil pan-to-timing case cover bolts and the cover-to-cylinder block bolts. ...

can I remove and replace lifters in my 02 wrangler sport 6 cylinder with just removing the valve cover? No, your would have to remove the rockers as well.

Remove the cover. Rotate carrier until you locate the bolt that holds the rod in place and remove it and rod. Rotate the carrier until one of the small gears come around and remove it and the shim and

...covers this in every step. are your covers off yet? and wheel? do hazards fail too??????? if yes, remove all lamps and replace them 1 by 1, lamps can short. (excess twisted) and test. 1 by 1. bad ...

Hold the camshaft sprocket with Special Tool 6847, or equivalent, while removing the center bolt. Remove the timing belt idler pulley. Remove the rear cover fasteners and remove the cover from engine