Questions & Answers for: Chrysler Cirrus remove cover

...cover off, any idea how to go about it? remove the harmonic ballancer You need to lossen/remove the Power Steering Support Bracket. This is a 2 person job. Using a stubby rachet, one person ...

...and that is how this support bracket is loosened.Remeber, you only need to loosen the last bolt, not completely remove it to free the left side timing belt cover.Hope this helps. Cause It was a

New Engine oil pours out from under valve cover... When adding change of oil to ''new'' used 1997 Chrysler Cirrus 2.5 V6, it all poured out from under valve cover when engine was turned on! Before ...

...remove the battery take off the left (drivers side) tire. then remover the battery cover/splash shield from the wheel well by turning the four plastic fastener's 1/4 turn counterclockwise. disconnect ...

...bolt holding air inlet resonator -loosen clamps on air cleaner cover -Remove PCV valve and hose -Remove EGR tube from throttle body Carefully remove items until you are able to access

...remove the plastic cover right in front of the tire towards the front of the car. The easiest way to remove the battery will be to remove the tire. It is a dumb location for the battery.....not sure ...

...cover. Remove the lower timing belt cover. Detach the power steering pump bracket from the engine. Remove the right (passenger side) engine mount and the mounting bracket from the engine. Make sure ...

remove the upper intake plenum and the rear valve cover.  Then the bolt can be easilly accessed by reaching over the top of the rear head.Hint: this is also a good time to replace spark plugs and

spark plug location The spark plugs are located in the holes on the valve cover. If this is a v6 engine you will need to remove the plenum to remove the rear bank spark plugs.

Remove the air cleaner cover, resonator, and inlet tube. Remove the EGR tube. Mark for identification and remove the spark plug wires from the distributor cap. Remove the distributor cap-there are two