...switch, also known as the headlight module. you have to remove the cover from around the steering column. there are usually phillips screws going through the bottom of the cover that hold it in
the stop ligths is off try changing the lightbulb by removing some screws on the back you can take the plastic covering off and then you would be able to remove and change the lightbulb
lower dash removal trying to replace heater core but can't seem to find the bolts to remove the lower dash The lower dash is pried off. Then there are screws for the heater core cover
remove the screws around the heater core cover. The ones near the firewall were a bit of a pain to remove and there is in the middle towards the firewall over the openning of the fresh air intake duct
remove plastic cover underneath steering column then take off the two bolts on a u-shaped clamp that holds the steering column up and let if fall easily to the seat now you should have a lot more room
...cover is what covers the actual heater core. remove that by removing the screws and it should come out also with relative ease. then on the outside of the car, almost to the bottom of the firewall, ...
Remove either the wing nut, upper cover retaining bolts or release clips from the upper top of the air cleaner and either lift off or separate the upper air cleaner housing or lid. Fig. Fig. 1: Remove
...cover on remove it them remove the bolt should be 13 mm slide the seat forward same thing remove plastic cover them 13mm bolt if it is power unplug power plug some seats have a seatbelt plug unplug ...
how do i put a water pump in a 95 chevy beretta http://www.youtube.com/watch?v=LAUuwBFM3KMI put a new waterpump on my 95 Beretta. Actually, it isnt that hard. I followed this video on youtube & ...
Question about 1994 Beretta
How do I get to the starter bolts to remove them for a 1994 QUAD 4 Z-26 chevy beretta? Remove the plastic cover first then remove the starter bolts.
Usually answered in minutes!
Step 2: Please assign your manual to a product: