...remove it. both cables have been removed. I have found what i think is one of the two bolts, but it has some sort of plastic cover near it preventing it's removal. i can not find the other bolt. I ...
...take the oil fill tube out to remove! I do not see a way to get to the spark plugs without removing this cover Twist the oil tube and the whole cover will come off. then tune up. Thats how you do
Question about 2002 LeSabre
...cover to obtain access to remove the heater coreHeater core retaining bolts and straps Heater core Fig. Using Hose Clamp Pliers tool J-37097-A remove the heater hoses clamp-Park Avenue Fig. View of ...
Question about 1997 LeSabre
...cover that I need to remove, but unable to figure out how. There is a bracket with a hook which the edge of the cover goes under, but that is the only part I can see holding it on. I do not like to ...
Wires are covered on top of the engines. I don't see any bolts to remove the cover. Does it just pop off ? yes, remove the oil fill cap and short pipe and then the cover will just pull off.
cover. Remove the inner and outer pump gears. Installation:Using petroleum jelly, pack the pump and assemble the gears in the housing. Tighten the oil pump cover-to-front cover screws to 97 inch lbs.
...next is to remove the plastic cover behind pulley, this is done by pulling it out then you will see the sensor, remove the connector and then remove the bolts holding it and out it comes, install
...is a flywheel cover and must be removed on some cars, remove the cover and then just look around and see if theres another bolt, take a look at the new starter and see how that bolts up. good
...gasket off to replace the gasket? You'll have to remove the brackets on the back side of the intake manifold to access the valve cover. Most likely you'll have to remove the spark plug wires,
Usually answered in minutes!