Questions & Answers for: Nissan remove cover

Ad

Question about Nissan

1 Answer

...REMOVE THE RADIO FACE COVER YOU WILL HAVE TO REMOVE THE STEERRING COLUM COVER NOW YOU CAN TAKE OFF THE RADIO FACE COVER IT JUST POPS OFF THERE IS TWO SCREWS ON EACH SIDE OF THE RADIO REMOVE THEM AND ...

Ad

...cover. Remove the drive belts from the engine. Rotate the crankshaft to position the No. 1 cylinder at the TDC of it's compression stroke. Remove the upper radiator hose and the water inlet hose. ...

Ad

Question about 2000 Maxima

1 Answer

...cover. Remove floor anchor bolt. B Remove shoulder anchor bolt. C Remove front and rear kicking plate, then remove center pillar upper and lower garnish. Disconnect seat belt pre-tensioner connector. ...

remove the front timing cover. After you have the bolts under the front cover that go through that lower oil pan, and the bolts all around the timing cover off, just work the cover slowly till it pops

...COVER.REMOVE EXHAUST MANIFOLD COVER FROM EXHAUST MANIFOLD RIGHT BANK TO GAIN ACCESS TO STARTER COVER BOLTS.THEN REMOVE STARTER COVER BOLTS AND REMOVE STARTER COVER.**** 5.6 V8 ENGINE YOU HAVE TO ...

cover. 9. Remove the upper chain tensioner (see Figure 2). 1995 Nissan-Datsun 200SX L4-1597cc 1.6L DOHC MFI (GA16DE) Page 3 10. Wipe off the links of the upper timing chain next to the timing marks on

Question about 1997 200SX

1 Answer

...Remove the thermostat housing cover by removing its bolts. There will be some coolant spilling out when the gasket seal breaks. Disconnect and remove the thermostat from its cover by removing its ...

Question about 1997 200SX

1 Answer

cover. 3. Remove the nuts and washers. Lift the cover off the cylinder head. Cover the oil return hole in the head to prevent dirt or objects from falling in. Remove the gasket. To install: 4. Replace

Question about 1994 Quest

1 Answer

...remove the cover screw, then pull out on the cover to release the clips. On 1995 vehicles, remove the five cover screws, then pull out on the cover to release the clips. Remove the four driver's ...

Question about 2003 Maxima

1 Answer

...cover.remove ign coils on frt valve cover and remove and install new plugsfor rear bank plugs you would need to remove upper intake plenum.  disconnect all necessary electrical connectors and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2005 Nissan Altima
2005 Nissan Altima

1,527 Questions

2003 Nissan Altima
2003 Nissan Altima

1,415 Questions

2000 Nissan Maxima
2000 Nissan Maxima

1,262 Questions

1995 Nissan Maxima
1995 Nissan Maxima

1,088 Questions

2002 Nissan Altima
2002 Nissan Altima

1,259 Questions

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

84966 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...