...control panel went blank. panel/ circuit break is fine... What part(s) do i need to replace? there is a thermal fuse in the back of the oven that more than likely has tripped during self clean poor ...
...control panel went blank and door stays locked. how do i fix heres the thermal fuses thats gone bad its mounted on the back wall of the unit youll need to get behind and remove the panel , unless of ...
Question about KDRP467KSS Dual Fuel (Electric and Gas) Kitchen Range
control panel. You need to remove the knobs and the front panel to get to it. You'll also need to remove a couple of trim pieces to keep from bending the panel. The part number is Whirlpool W10017820,
Question about KDRP467KSS Dual Fuel (Electric and Gas) Kitchen Range
...control panel thermal fuse (Microtemp G4A01093C). Its in the wiring harness between the control transformer and the control panel on a blue wire. It looks like a resistor inside a clear plastic tube ...
Question about KDRP467KSS Dual Fuel (Electric and Gas) Kitchen Range
control panel. You need to remove the knobs and the front panel to get to it. You'll also need to remove a couple of trim pieces to keep from bending the panel. The part number is Whirlpool W10017820,
Question about KDRP467KSS Dual Fuel (Electric and Gas) Kitchen Range
...I don't recall a control panel fuse for this model, there is, however, a thermal cut-off on the rear of the unit. The part number is 8300802 and you simply have to remove the rear panel to access
Question about KDRP467KSS Dual Fuel (Electric and Gas) Kitchen Range
control panel. You need to remove the knobs and the front panel to get to it. You'll also need to remove a couple of trim pieces to keep from bending the panel. The part number is Whirlpool W10017820,
Question about KGSI901PBS Gas Kitchen Range
...remove the cover over the control panel but could not get anywhere after removing the burner control knobs. I've also read of numerous problems with the control panel after using the self cleaning ...
Question about KDRP467KSS Dual Fuel (Electric and Gas) Kitchen Range
...control panel. Then remove part 4457249Face, Control Panel (two screws, right and left, under panel). DO NOT DROP PANEL. The panel is connected via wires so please be careful. Set the panel on the ...
...control panel? Remove two screws beloe the panel just above the door. There might also be two screws, one on each side/end of the panel. Lift panel to loosen. Sometimes grease makes it hard to come ...
Usually answered in minutes!
1,163 Questions
465 Questions
395 Questions
390 Questions
353 Questions