...Thanks Remove the muffler and clean the exhaust port, spark arrestor screen and muffler intake. Rebuild the carb, costs $10 for the kit and a monkey could do it. You need a phillips
...remove this screen There is no point in messing with the setting until you clean the carburetor. it sounds like that is your main problem. Or you may need a new carb. kit, depending on how old the ...
...and it will eventually, your engine will start and run, but it will not want to run at higher rpms. You have to remove the muffler, then you just clean the screen. Try that. It's a relative easy
Question about ECHO, Inc. PB-251C Handheld Blower
...at top speeds. I have removed carb and cleaned it, even though it looked very clean. Jets are clean and open. CHECK AND MAKE SURE THE MUFFLER INT PLUGGED ALSO REPLACE THE FUEL FILTER INSIDE THE ...
Question about ECHO, Inc. PB-251C Handheld Blower
...remove the muffler and visually inspect the muffler port. If it is clogged, rotate the piston to the top of the cylinder and using a dull small screwdriver, chip away at the carbon until you have it ...
Question about Gas Blower 135 MPH390 CFM Blower PB250
...idles fine, will not throttle up. Sounds like restricted exaust. Remove the muffler and start it, see if that fixes it. If yes clean remaining carbon from exaust port. And clean spark arestor
...new carb on. checked keyway. new spark plug. still will not start remove the muffler and try it carbon plugs up the screen inside if runs good with out the muffler open the muffler and clean the ...
Question about Gas Blower 162 MPH 450 CFM Blower PB500H
echo leafblower starts but no power Could be Excessive carbon build up in exhaust caused problem. Remove muffler and clean exhaust side of cylinder.
Question about ECHO, Inc. PB-251C Handheld Blower
...starter cord but that's all I get, so what's still wrong with this thing? You might need to check the compression on the cylinder. Spark arrest in muffler could be clogged. Remove muffler and
Question about ECHO, Inc. PB-251C Handheld Blower
...in the muffler is plugged with carbon. The back pressure will stop it from running. My suggestion? Remove the muffler. Clean all the bits in solvent and air blow dry. Re-assemble and Ta ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions