Questions & Answers for: remove blend door 98 ford

...to remove door panel to replace door handle on 1998 Ford Ranger. Remove the door panel and on the inside of the door is a clip or a couple of nuts you'll need to remove. The door handle will fall

blend_door.jpg Click on the link. I know you didn't want to remove it, but. I don't know if you could get at it through the glove box cavity? As far as loosening the instrument panel, I'd have to look

...remove interior door panel(need special tool to pop plastic clips holding panel to door)with panel off remove plastic film,with window up you should be able to see two 10m nuts-bolts to remove-also ...

...blend door and the electric actuator that moves it, which takes all day and u must remove the dash or you can install an after market kit that resolves the problem is about 2 hours, here is a link to ...

...blend door works then its got to be the core particaly blocked, also are you sure your looking at the blend door.try removing hoses from core then back flush with waterhose, go both ways, hope this ...

...blend door has broken and stuck in the cold postion and you may alsohave a vaccume leak check the direction of the air with the truck stoped chainge the seetings to floor andif itworks y the truck is ...

i have a 98 ford ranger the ac blows out the windshield vent only not the vents that face in mode switch can be at fault or a stuck blend door

...blend door motor has perhaps failed with the blend door in the semi hot position. Blend door motor failure is very common on the Ford truck HVAC systems. Is is located behind the glovebox on top of ...

...remove the dash to replace the parts, the blend door and the blend door actuator motor should both be replaced at the same time, the common reason for the motor to fail is a sticking hard to move ...

...blend door down by the floor discharge was broken.go to heatertreater.com and watch their video. its about the only solution unless you want to pull the whole dash.they have the parts to fix it