Questions & Answers for: remove belt tensioner 2000 jeep

...remove bolts holding fan clutch onto water pump pulley. 7) Pull out shroud, then fan, then fan clutch. Be very patient, lots of wiggling may be needed. 8) Locate belt tensioner on idler puller below ...

...belt. Remove lower radiator hose clamp and remove lower hose at water pump. Remove seven water pump mounting bolts and one stud bolt CAUTION: Do not pry water pump at timing chain case/cover. The ...

...remove belt tensioner??? trying to remove my tensioner on my 2000 jgc but doesnt seem to have a bolt??? looks like it only has only one alan wrech screw or something?? i need to replace it. can ...

...belt replacement remove and replace the timing belt on a 2000 jeep grand cherokee 4.0 liter I-6 engine If you have the same pulley arrangement that most 4.0 engines have that pulley is an idler not a ...

...remove The opposite direction the pulley turns. However, if you are trying to get the serpentine belt on or off, this will help. It's easy and doesn't require a prybar. Get a 14mm or 9/16" socket and ...

belt off Use a ratchet to take four bolts off of fan remove it set aside. Loosen all bolts from power sterring pump only one will have to be removed. From there you can slip out and replace water pump

...2000 Jeep Grand Cherokee wont hold a charge and needs to be jumped. When trying to start it makes a clicking noise and the console instruments jump. Is this the battery??? Or the alternator?? Or ...

...remove the alternator drive belt. Step 9 Using the proper size socket and ratchet, remove the alternator mounting bolts, spacer (if equipped), adjusting bolt, lower pivot bolt (if equipped), and the ...

...Remove the old belt. Thread the new belt onto the pulleys in the same way the old one was on. Allow the tensioner to push on the belt once again, or tension the belt by moving the alternator or power ...