...battery first? my bearings went and the thing was screaming. Yes, disconnect the battery. Remove the belt. Disconnect the wire leads from the rear of the alt. Remove the bolts. Reverse steps to ...
...battery cable. 2] remove the serpentine belt. you need a socket wrench to remove the tension from the idler arm pulley. 3]disconnect the battery wire from the alternator, and unclip the other ...
...won't start unless I jiggle the positive starter cable. check cable at both ends make sure its tight.move it @ starter see if post on solenoid is loose.remove battery negative before taking out ...
how do I remove battery after cables are released on 2003 gmc sierra There might be a clamp at the bottom of the batery otherwise just pick it up
...remove a battery from a 2005 gmc sierra? we can't get it out. you will have to remove the cross brace and then the battery hold down retainer. the retainer is a 13 mm headed bolt Remove the front ...
...the negative battery terminal, remove the two screws at the back of the steering wheel that hold the air bag in place, pull the air bag up and disconnect the wire. Reverse order for
...remove windhield washer reservoir in a 1998 gmc sierra 2500. So far I have removed the auxillary battery box, diconnected everything from the top of the reservoir but still can't get the ...
...to install There are just two bolts to remove the starter. Make sure power is disconnected from the battery before you start work. You access the starter from under the truck on the passenger
...remove a battery from a 2006 gmc sierra I can't remove the battery to replace it ith a new one. I can't find a bracket or a bolt to remove and lift the battery up and out. The old battery slides ...
Question about 2006 Sierra
I have an 06 gmc Sierra truck security alarm on steady need know how to reset Simply remove the positive cable from the battery, count to ten, then reconnect. That should do it.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions