...Remove the alternator mounting bracket 10. Remove the electrical connection on the alternator 11. Remove the alternator by turning the alternator until it will come out of the opening 12. Repeat ...
...remove a alternator from a 2001 mazda tribute 6 cylinder First, disconnect battery, than remove cables from starter (you may want to make mark so you don't get them mixed up when reinstalling, Than ...
Question about 2001 Escape
...2001 Mazda Tribute Seems worse at start up or when wet. Your fan belt is slipping. As you turn the wheel you make a power demand on the power steering compressor. This compressor takes its power from ...
Question about 2001 Tribute
...alternator is not charging the battery. Remove it and have it tested at your local parts store. Fully charge the battery with a charger. If the alternator tests good, reinstall it and start the car. ...
...alternator mazda tribute how complex is it to remove and install a new alterantor? I thought that it could be remove from the under the hood but later found out it had to remove from underneath. How ...
Question about 2001 Tribute
...alternator and battery on my 2001 mazda tribute. now the battery drains if the vehicle sits for one day. could it be the positive cable. the battery gives out 12v and fires right up when jumped. and ...
remove alternator Disconnect the battery cables. Refer to BATTERY DISCONNECT. 2. Remove the right intermediate axle shaft. Refer to HALFSHAFT-FRONT. 3. Remove the right lower splash shield screws and ...
Question about 2001 Tribute
How to remove the alternator in an 2001 Mazda Tribute 4 cylinder? Disconnect battery , remove the driven belt,remove belt,remove wire and push in plug remove long bolt lift away from motor.
how to remove the alternator of a 2001 mazda tribute Mazda 2001 and 2002 think are same. click link take you to video on how. All best Clive https://www.youtube.com/watch?v=yZCeAHWDKPI
Question about 2001 Tribute
remove the connections and clean them off with a wire brush and do the same to the terminals, once done reconnect neg 1st then pos. Try cleaning battery points with wire brush Could be a brush hanging
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions