4T65E transmission in this vehicle and the TCC switch/solenoid is part of the valve body and the valve body is on the side of the transmission (drivers side) and would require at least the lowering of
...4t65e transmission. What could it be? You need to drive it with a scanner on it to see if the pcm is commanding 4th. If it is then it likely has a broken driveshaft to the 4th clutch. This is common ...
...remove and replace the 4t65e transmission in my 01 impala with experience. If you have to ask it sounds like you shouldnt even attempt this, I'm a mechanic and I dread these. . I defineatlely wouldnt ...
...4t65e transmission and it is shifting hard after running for a while. I checked the fluid level and it is way over full. What would cause this and is there an easy fix to this? not really, the EPC ...
4T65E transmission is costly to rebuild, keep the fluid clean. on the right side of the motor you can see the trasmission there is a dip stick that is almost tight to the engine usuall red i color and
...4T65E TRANS HAS LONG 1 2 SHIFT AND SOMETIMES GOES INTO NUTRAL ON 1 2 SHIFT UNTIL YOU LET OF THE GAS AND RPM COMES DOWN, ANT IDEAS... Have it rebuilt I have worked on several of these transmissions. ...
Question about 2000 Malibu
...4T65E transmission. This switch serves the same purpose as the typical external neutral safety switch. The Internal mode switch is inside the transmission. You can verify that you have the internal ...
Question about 2000 Malibu
...4T65E transmission are located on the valve body, which is located within the transmission side cover. The amount of work necessary to get to the solenoids is about 20 minutes less than removing the ...
4t65e transmission without removing it from the car? Im trying to avoid pulling it as i dont have a trans jack and im not dropping $200 on one for a one time use Rent a transmission jack from Autozone
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions