KLX 125 sat for 2 years, carb removed, cleaned, cleaned, cleaned, re-installed no air filter restriction, runs great at 600- approx 2500 rpm then 2/3 throttle to full throttle, bogs. all passages ...
125 looks to be not broken or chipped or bent open in any way... The reed valve assembly should hold solvent withot leaking. Remove for test. Disassemble and clean reeds and reed seat. Perfect seal is
bike backfires i took my bike on the beach { not near the water} and all was well but now bike wont start and bikefires .when kickstart or bumped ... any help pls Sounds like sand in the reed valve ...
kawasaki kx85.wouldn't start.i fitted a new lower ign coil so now it starts.but after it is started and stopped it is hard to restart. look for a crack in the spark plug, wire,etc...may be getting hot
...80 HAS 65 PSI COMPRESSION AFTER TOP END REBUILD VERY HARD STARTING You may have a problem with your reeds.If you have done a rebuild because something internally has destroyed itself then the chances ...
My 03 KX125 just had a new crank kit and top end installed. Bike ran great first few times out. Now it's misfiring under a load. It revs great in neutral and is very responsive, but when accelerating ...
...6. Float needle is not seating. 7. Faulty reed valve. For more information about your question please visit the website below. Good luck and have a nice day. Manual Kawasaki Bajaj Wind 125 ...
can i put a bigger reed valve in my kx 125 No u can't.
...Kawasaki KMX 125 it was fine one day then it wouldn't rev up was running poorly and wouldn't go faster than 12mph I checked reeds and cleaned the carb then it worked fine for 2 days then done exactly ...
Question about 2003 KX 125
...http://vermijsmotorsport.nl/manuals/kx125250-030408.pdf OEM Parts for Kawasaki http://www.kawasaki-techinfo.net/searchOM.php?view_lang=EN&spec=OC&book_no=&lang_code Kawasaki KX 125 ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions