Questions & Answers for: reddy heater wont start back

...reddy heater 55,000 btu my heater wont lite warm or cold, you have to plug it in at least 30 times before it will finally start, then it will run fine . I'm guessing it is the pressure screw on the ...

...REDDY HEATER 55000 BTU. IT ALWAYS RAN FINE BUT NOW IT WILL START UP THEN IT SHUTS OFF AND BLOWS ALOT OF SMOKE. IT WILL KICK BACK ON AND SHUT OFF AGAIN BUT ITS TOO MUCH SMOKE. SO IM GETTING FUEL AND I ...

...reddy heater, it has always worked fine, it was very dirty after the flood, I power washed it off, drained the old fuel out of it,thinking it may have water in it, put clean fuel back in it, plug it ...

reddy heater 55000 btu R55A wont stay running runs for awhile then goes out after about 10 min. unplug it and it starts right back up. new filters and newer ignighter. any ideas would be appreciated. ...

wont start cleaned the air filters, and put it back together.and it wont start, the ignitor lights fuel sprays and blower works..but still wont burn Change the CAD flame sensor, it's a $3 part and ...

to spin it by hand, if it wont spin replace the fan motor Try opening the cover, tilting the unit up to about 45 degrees and spraying WD-40 on the front of the fan shaft, then plug in and try to start

...and the fan motor gets hot. its a reddy heater 125t. it runs off either number 1 or 2 kerosene or number 1 or 2 diesel. A bad capacitor can cause the fan to act like yours. I would check that

makes noise when i plug it in but it wont start Does it have a pressure gauge in the back by the fan?

heater fires rite back up,runs for a minute or two . Plenty of kero in tank,trying to avoid putting alot of parts on it thats not needed.it runs just wont stay running afrye44698, See my tip at http:/

heater worked good and it started shuting down now it wont run with out restricting the air coming in Make sure your pressure setting is right, it should be 5.1 psi.  If you want send me an email