...Led is flashing green then turns red. Here's a few things to check to help you narrow down the problem, if these make no difference, post a reply to this thread with your findings. First, make sure ...
Question about Rc Revo Nitro Monster Truck
...wont my Revo R.C. car respond to its remote? Make sure batteries are good in the transmitter and receiver pack. Check antenna for damage. Check u have the corect crystals a maching pair Make sure ...
Question about Rc Revo Nitro Monster Truck
How do you change the throttle servo on a revo 3.3 Disconnect the servo at the receiver, remove the servo horn and linkage from the servo. Remove the four screws that hold the servo to the chassis. ...
...or try to move. If it does not make any noise when you turn the wheel on the controller open the receiver box and make sure that the steering servo has not come unplugged from the receiver. If ...
...sure it has not loosened up. If the servo is not trying to turn at all check the connection at the receiver. If it is okay, you can always switch the steering and throttle servos at the receiver to ...
...This happened after i crashed it pretty hard after a jump. Hi You have lost battery power to the receiver. Check the wires from the battery to the receiver, check the battery while you're at it. ...
esc won't respond to remote on my e-max Hi the ESC does not respond to the transmitter. The receiver responds to the transmitter. If the receiver channels are working (swap the steering servo between ...
Hello, i like to upgrade my traxxas vee with a 2.4 ghz link radio. the old 27 mhz system in the boat runs on 7.2v. will the 2.4 ghz link receiver operate on 7.2v i dont know contact you service
how do you change modes between lipo and nicac push switch to turn on truck then Hold down the esc switch for approx ten seconds. You will hear a chime and then the led should change from either~ red ...
Question about Link 2.4 Ghz 5 Channel Receiver P/n 2218
...LED ON 2218 TRAXXAS RECEIVER CANNOT GET GREEN LED ON THE 2218 TRAXXAS RECEIVER WHEN i HOLD DOWN THE LINK BUTTON AS i POWER IT ON. MY TRANSMITTER (#2239), HOWEVER, GETS THE GREEN LIGHT ON IT BUT ...
Usually answered in minutes!
103 Questions
84 Questions
50 Questions
19 Questions
14 Questions