Questions & Answers for: rear end seized

is no tag on my defferential.Thank's there should be a tag on rear end to check rear end, there are 4 different seizes for that car. 16 is 3.73 ,17 is 3.31 ,19 3.55 pos track. and 19 3.55 limited slip

Ad

rear axle nut on my harley Harley manual says 60-65 ft lbs... do NOT exceed this or wheel could seize 60-65 ft/lbs when putting axle back in though make sure you use a generous amount of anti seize on

Ad

Question about 2002 Tahoe

1 Answer

rear end noise and seizing now i had a rear wheel seal leaking i replaced it when axle was out rear differential was removed also as the lock bolt broke off now after new seal and lock bolt and ...

...rear calipers are seizing. How can both calipers go bad at same time? Do you live near the sea? Do you use the car to launch a boat ?. The third idea is, how often do you replace the brake fluid. I ...

...rear end hopped, jumped, and swerved violently. I took the rear cover off and no fluid was present. I am wondering how to unsieze a siezed up rear end. No gears appear to be broken including the ...

Question about 2001 Montero Sport 4WD

1 Answer

...rear caliper piston,if applicable, and manually ratchet up the parking brake,after caliper and pads are on. Bleed/Flush all 4 Wheels. Make sure you can slide the pads back and forth,before lubing end ...

Question about 2005 Ram 2500 Truck

1 Answer

rear end noise, shaking just started noticing my truck seems to be shaking more as I increase me speed, had tire rotated, balanced and aligned, front U joints replaced. still happening. sounds like a ...

rear end skidding out on sharp stops, wet roads and inclines . To do this there is a small pressure regulator ( equaliser) that allows some pressure through at partial brakes eventually increasing the

...rear end up put it on stands remove the drive shaft and see what turns if the wheels spin freely its not the rear end its clutch or transmission if not then its the rear end witch you would be better ...

...rear end. I can't believe it would lock up the motor being hit from behind. I would check rear swingarm, chain alignment and mainframe thoroughly for bends, breaks or anything else out of shape or ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...