...and I have bought a duralast gold replacement from autozone. I have everything taken apart and ready reassemble but I cannot get the mech fan off the old pump to transfer to the new pump. ANy ...
. What it basically means is that driving conditions are not optimal so if you see that message, be ready for some sort of weirdness while steering
...change out the first time but... The tansmission will change out the first time but when it get ready to change out the second time it will not like it slips out of gear then when i get off the ...
...the seal and bearing You will need to pull the rear end cover off,make sure you have a drain pan ready. when you rotaye a rear tire the ring gear will turn,look for a bolt head on the spider gear ...
...good luck if both dash and radio- check dimmer switch on lighting control- could be getting ready to ...
Sensors not ready 2001 Chevy S10. I have driven more than 500 miles and sensors still read not ready. 02 Sens Not Ready, 02 Sens Htr Not Ready, Catalyst Not Ready. This is the heater side of the ...
...are many parts for this system under the hood all the way back to a can near your fuel tank, so get ready to learn about what does what in the EVAP system. If it's something else (no codes) let me ...
catalyst not ready on 2003 yukon keep driving it. it takes time once the codes are cleared for all the system checks to take place. This was done by the auto manufacturers to help eliminate the check ...
Question about 2004 Yukon
...traffic. Made a noise as if hitting rev limiter and then did not notice anything until after I already parked and got ready to leave and will not go in reverse. Pushed it out the parking space and ...
Question about 2004 Yukon
2003 GMC yukon 5.3 engine flex fuel no ck engine light on, yet when they go to inspect it it shows 3 inc codes. what can cause this? 3 inc codes ??? 3 incompleat code's.? Not code's - Readiness ...
Usually answered in minutes!
593 Questions
524 Questions
309 Questions
326 Questions
238 Questions