Questions & Answers for: raised clutch pedal

clutch pedal floppy 1991 nsx suddenly clutch became floppy and fell to the floor. gears won't change. fluid levels ok. engine runs ok no warning lights. had to be towed. 40,000 miles on car, no mods. ...

...clutch pedal.then open the bleeder screw. then close the bleeder screw.and have helper release the clutch pedal repeat the procedure until all of the air is evacuated from the system.keep check on on ...

...clutch pedal to uppermost position to disengage clutch and brake pedal pivot shaft. Push clutch and brake pedal pivot shaft forward and unhook clutch release lever cable from clutch and brake pedal ...

clutch pedal stays to the floor and car is now stuck in neutral. Can raise the pedal with hand but will not raise on it's own clutch hydralics is gone, meaning you have a leak, check clutch master ...

...clutch pedal is being raised there is no noise. The clutch seems to operate fine. Have you heard of this and if so is it easy to fix ? sounds like the end of the cable is frayed ,but again i would ...

...to raise pedal up: Replaced clutch and the pedal is not returning all the way back up. 1972 dodge charger you need an adjustable clutch rod for under the dash I found one for my ford in the junk ...

clutch pedal to high is a new clutch cable required or can it be agusted manually for my honda crv 2000 Hello When the clutch pedal gets high that means the clutch disk is worn out, as the disk thins ...

clutch pedal making cracking noise(like when you squeeze plastic bottle) now pedal gone loose and biting point moved up inch or so so i have to completely raise clutch before car will pull away but ...

...clutch pedal 60-100 times. Verify clutch operation/pedal feel. If pedal still feels spongy, or clutch does not fully disengage, excessive air is still trapped within the system. Perform the following ...

...clutch pedal You adjust the pedal height by turning the clutch master cylinder pushrod which is attached to the clutch pedal under the dash. Loosen the locknut and turn the rod to raise or lower the ...