Questions & Answers for: putting clipper blades back together

...I am unable to get the blades back on this clipper. Oster Golden A-5 Found another web site where some one had posted the information I needed. I just used Google search and found the

...clipper & need to change the blades. The instructions tell how to do other tasks like oiling & changing brushes, but not blades. Can you help me find a more complete manual or get instructions. I can ...

...clipper make sure the white piece goes in the hole that rotates the blades and sould go in fine i've accidentally dismantled my wahl clipper 9639 model and can't fix the blade back . please ...

...to put them back together. Can you help. the oster clippers are usually mounted with spring tab to remove blade.Should be no reassembling. If there is, it should be a couple of screws that you screw ...

Putting back together hair clippers I cant seem to put back together a pair of Conair hair clippers. how does thespring come into play are u talking about the clipper it self or the clipper blade i ...

...clipper-blades-the-parts This picture whows the front and back, it differs slightly from your blade, but its same meat different gravy! Hold all this together with your finger and thumb, flip it over ...

...clipper clatters (buzzes really loud) and then adjust it back until the clatter stops (but not too far or you will lose power and the blade will stall or cut slowly). Be sure to oil the blades. ...

...back together and although they clip a little they do not do anywhere near a good job as they did before. What should I do? Sound as though the blade drive needs replacing, commonly you will notice ...

...back together where does the little thin white plastic piece go I suspect you are referring to the blade guide which sits under the spring on the clipper blade and rests on the top of the cutter in ...

...putting back on a few times and it would work again. The other day clippers started makingh a loud sound in the middle of groom and blade was no longer moving. Still won't work, will power on without ...