Questions & Answers for: put lower threading case brother

...lower the presser foot and while pulling on the thread with your left hand, increase the tension with your right hand. Do it slowly and you should feel in difference in tension. If this is the case, ...

...put it on. I am not sure whether I am threading it correctly or not. Do I need the manuel? I don't know what I did with it. Someone told me that the thread was too old. That was the reason for it ...

...Put the bobbin case in and make sure it is seated correctly. If all this fails try replacing the needle. A blunt needle can cause all sorts of weird problems Nesting on wrong side (bottom) is usually ...

...lower thread (bobbin thread) while stitching, as it seems to be very loose. Hello On your bobbin case where you run the thread through the case you will see a plate with a screw on top of the bobbin ...

threading sequence is correct and the thread has not slipped out of the take up lever. Hold onto the top thead end and lower then raise the needle to pull up the bobbin thread. Pull both threads under

case correctly? Every aspect is critical to proper function. You may also want to revue your manual. The upper thread is NOT threaded correctly. Put your tension dial back to where it should be and re

...Put fabric scrap under presser presser foot and LOWER it now. Make sure, too, that the needle is correct size for fabric you're sewing. 9. Do a test. You may need to set tension at 4, stitch ...

...put it back right Bobbin thread breaks 1. There is a right way & wrong way to insert the bobbin in the case --when you insert the bobbin in if it doesn't stitch correctly turn the bobbin over see ...

...lower bobbin. No matter what I did then bobbin would unwind and jam up.I received the E6 error a few times now. ALso, the upper thread seems not to have any tension at all. there is no difference ...

...lower, upper gets caught and crosses). Tension and length set at 3. Straight stitch set but when jam (tangle) occured I was using decorative stitch 6 on light fabric with size 11 needle.I have ...