...put gas in the tank the car failed to start and I am not getting any power to the Low pressure oil switch now The Circuit diagram shows it coming from the instrument cell cluster. According to the ...
...put a pump in the tank and got about 13 miles and it died again, Now i have no pumps, I also replaced the fuel relay's that click when you turn the ignition on, and the ignition module, and the ...
...or need new parts and check ignition switch also does this have tilt steering could be a bent rod connects igniton switch to ignition key clyinder (where you put your key in and turn)hope this ...
...put electrical part of the ignition switch on and it did the same thing, have checked wires from starter, coil, starter relay, fuses and cant find anything that would be causeing the problem..any ...
...put in the key and everything lights up. Turn it and it sounds like it starts and then everything immediately dies. When I first noticed this phenomenon I was able to get it to start and remain ...
Question about 1988 Ranger
ignition switch. It is usually located on the drivers side of the steering colum about 10 inches above the floor. Make sure the key is in the off position before you start to take the switch out.. the
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions