Questions & Answers for: put hand carb stays running

hand when working on carburetors. Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or

Ad

...hand when working on carburetors. Open the petcock, (gas valve), and drain 1/2 cup of gas from the tank. Did the fuel flow freely? Is there any water or trash in the cup? Drain the carburetor. There ...

Ad

...3) Try it. 4) Start it with the choke on and put your hand over the air filter hole. Will cause some back flow. 5) Try again. Worked for me. Might be dirtier on yours, or have mud in it or

...hand to put the filter back on, it will die. I tried changing the air/fuel mixture but I can't seem to adjust it enough to slove the problem. What should I do?! with hand off ur not gitten enuf ...

Question about Rc Revo Nitro Monster Truck

1 Answer

...put youre hand where the exhaust is and you should get a light spraying of unburnt fuel over hands(lovely!). If you do you may be able to screw in high end needle in a bit and i mean just a bit. If ...

...put my hand completly over the hole on the air filter it will run on low idle but as soon as i remove my hand it stops looked at diafram looked ok whats the problem remove the gas can carefully the ...

Question about 1997 XV 535 Virago DX

3 Answers

...put new gas in sprayed carb shut right off blew gas lines out .won't start now. HELP 1 Sound good ,it started the carbs probly need a good clean ,mind don't mix parts from one to the other ,they ...

...hand runs fine, Any ideas on what I can do? Engine surge is usually caused by one of two things... 1) a lean condition. Not getting enough fuel. 2) throttle plate shaft in carb is worn. ...

Question about Lawn Mower With Toro Power Tools

2 Answers

hand over the inlet of the carb, not block the airflow completely but restrict it, if the engine stays running blow out the carb jets with compressed air. You have to take out the brass 'bolt' holding

...hand over intake on carb? Lots of suction . On. A craftmen 24" snow blower , only 2 years old ,stays running with thumb over intake on carb ? Dirty carburetor . If it has a fuel cup on the bottom of ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66949 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...