Questions & Answers for: put dewalt drill case

will not put a teck screw in when i try to put a teck screw in the gun jut rattles and there is not enough power to put a screw in You need a new battery.

...in reverse My Makita drill has gotton itself stuck in reverse HELP! I am right in the middle of putting up a new ceiling! Use left hand screws.....or take housing apart to see what has jamed the ...

...dewalt 12 volt drill Hi there, Remove the battery and sometimes the screws on the drill casing are a torx instead of phillips so you will need a set of torx screwdrivers. Once you have removed the ...

...dewalt drill charger started smoking when i put the battery in although it wasn't even pluged in to the wall and now won't work If this is for the 14 and 18 volt batteries, this is what I found had ...

...you get the dewalt dc 390 cordless saw back in the case. darndest puzzle I ever saw Take the batt. off and drill bit out. Also make sure you are putting the drill away on the correct side of the

dewalt cordless drill which I used regularly. In the middle of a project, I put in a newly charged battery and it immediately started to smoke from the battery case. I assumed that it was due to a bad

...put a drill bit? An impact driver won't work very well as a drill. In fact it will probably break drill bits in anything but very soft material (like drywall). A drill bit needs a smooth continuous ...

...dewalt 18v dcd970? The chuck on your drill was made to be taken off with a special jig and holder that cost $175+.  Depending on how tight and how much lok-tite the factory used some chucks ...

dewalt keyless hex chuck? It only accepts 1/4" hex shank bits and nut drivers. Mine just pops in and to release it, you push the black collar around the bit down. Cannot put round end bits in it. Only

Dewalt 20v battery on the dcb106 charger. When I put on the battery, the light flashes like normal but then dies out in about 3 seconds. Problem with charger? I'm planning to exchange tomorrow morning