Questions & Answers for: put crank sensor 2006 nissan

...2006 nissan 2.5 liter engine so can be replaced codes said sensor was bad THE CRANKSHAFT SENSOR IS LOCATED ON THE OIL PAN. The crank shaft sensor is easiest to get at from under the truck, VERY

...put a fuel pump repair kit on what else can it be Spark? Did you check it for spark? Oil? Gas? Coil ok? How about them wires? The crank sensor is a big one, or the ecu itself, coil pac., anti theft ...

...po725 code its engine speed fault ,replace crank sensor.for vehicle speed there are two identical sensors near each other on trans....one called revolution sensor other is called turbine speed

2006 2.5lt petrol X trail. Car is hard to start, can take up to 15 goes before it starts.have replaced both crank angle sensors Done just over 100,000 kl. Hard starting, but oddly enough starts ...

O2 sensor on 2006 Nissan sentra location of bank 1, circuit 1 my code p0420 2006 nissan santra 1.8 cut off why drive some time in hard to crank up when it do that

...Sentra starting problem I have 2006 Nissan Sentra 1.8L and it is hard to start. I start it but after I turn it off I have to wait for a while to start it again replace the crank shaft position ...

my 2006 nissan altima wont restart. have to wait for engine to cool. put a new fuel pump in, but still wont wont crank after i shut it off. also put in new spark plugs check the crank or cam sensors.

...code po 335 on a 2006 nissan 350z Code 335 is for a problem with the crank sensor.  It could be a faulty sensor, the object the sensor reads, or the wiring from the sensor back to the

how to replace crank sensor 2006 nissan altima Please watch this YouTube video on the sensor job. The car must be raised to access this sensor.

...crank sensor in 2006 nissan sentra. Still get code po335. Sometimes it cranks,sometimes it doesn't. Now what? Here's a link to your code P0335. http://www.obd-codes.com/p0335 The sensor you took out ...