...chevy cobalt car? Or where to find them. Thanks! you must remove all the plastic face plates around the radio then remove the radio itself.be cautious as you could damage the clips that hold the ...
...clutch. Put gm stage 1 clutch and it will not shift 1st to 2nd when getting on it .Does not shift smooth. Sounds like you are not getting the full throw of the slave cylinder. If you do not disengage ...
...so i cant engage or disengage the clutch with a new master cylinder, new slave cylinder, and pressure plate and clutch check clutch installment procedure could be the problem how it was
...liter ac clutch not comimg on 2007 chevy cobalt 2.2 liter ls ac clutch wont come on. I turned the clutch by hand and didnt have a lot of resistance.any ideas i think the system is low on gas, check ...
Question about 07-10 Chevrolet Cobalt 5 Lugs W Rear Discs Exc Ss Front Diamond Slot
...the tranny end of the linkage move. How likely is it that I'm going to need to replace my clutch? Yes your clutch is dead make sure you check your throw out bearing clutch fork and finger plate as ...
Question about 07-10 Chevrolet Cobalt 5 Lugs W Rear Discs Exc Ss Front Diamond Slot
...Chevy Cobalt, standard transmission (5 speed) with about 60,000 miles on it. About a week ago it started putting off a thick burning plastic smell that originated from the transmission side of the ...
Question about 2007 Cobalt Coupe
...is it that I'm going to need to replace my clutch? if you can smell burnt friction material, and if possible see it around trans, ( will look like black fibers everywhere) you fried your clutch
Question about 2007 Cobalt Coupe
...http://answers.edmunds.com/question-Clutch-issues-05-Chevy-Cobalt-191379.aspx ...
Question about 2005 Cobalt
...put in a new flex plate drove it for a couple months and it has broke again. Any ideas why it keeps breaking Make sure it bolts up to the converter with out any stress, the converter and drive plate ...
Question about 2005 Cobalt
...pipe lines for leaks. bleed system and be certain hydraulic pressure maintains .If problem persists check and replace clutch master and slave or might be a rare case of a faulty pressure
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions