Questions & Answers for: put chain back sprocket

...put in gear grinding noise was deafening and chain seams to kick. now ordered new chain and sprockets , but is there something else what it could be. thanks alan No.That was the problem.The chain and ...

...on bar 3) Debris caught inbetween bar and chain 4) Sprocket teeth are worn out Sounds as if you need to put bar oil in it or the chain is to tight. If you need further assistance, let me know. ...

...Put the bar with the chain around the sprocket back on the saw, reinstall the cover with the two screws/nuts, but do not tighten too tight.(You will want to be able to move the bar with the chain.) ...

put the assembly back together. Stock gearing is a 13 tooth front sprocket and 48 tooth rear sprocket. The stock chain is 112 links plus master link. The chain is DID 520D 112L. Please rate my answer.

...put the chain on a middle sprocket. You don't have to hit the exact correct sprocket as you can simply lift the rear wheel and turn the pedals forward (after installing the wheel) and the chain will ...

...back all the way to the left. Then put the chain back over the sprocket, then onto the bar. Put the chain cover back on and tighten the chain back up. Then tighten the two nuts back to

...put on a chain cant get it back togather right Completely loosen the chain tensioner.  When looking at the saw from the sprocket side(bar to the right) the chain WILL travel ...

put a chain on a 250 trailblazer 250 every time i get it on the master link pops right back off i have litterly went through at least 15 20 links in the past day and a half!!! HELP Assuming you put on

...the new sprocket to begin wearing prematurely. If you recently swapped chains did you put on the correct pitch? Normally this saw uses a .325 chain; unless, someone has modified it to use .375

...The chain has slipped of it's sprocket/cog and needs putting back on. Go into the garage and git a step ladder and remove the chain cover and put the chain back onto the sprocket and see how ya