Question about Go-Go Elite Traveller Scooter - 4 wheel w/12 AH Batteries & Charger + Flat Free Tires - Silver
...put on charge the charger shows its fully charged. When the scooter is swithched on the volt meter illuminates but doesn't register any charge at all, the horn works but thats it. The reset/cut out ...
...need to replace them. Or take them off the chair and put them on a car charger,slow charge. They need to be up over 24VDC. If they fall under 24VDC the charger won`t recognize them and won`t
...car charger. I put the two battery in parallel and used a amp battery charger. This worked fine. Don't run your scooter batteries all the way down when using the Go Go as the scooter charger won't ...
...car battery charger, put the batteries in parallel by using jumper cables then hook chargers to the batteries. Sometimes the scooter charger will not fully charge. Use 6amp or lower setting while ...
...put out the full power. the best way to test this is to take the batteries down to your local car garage and ask them to do a "load test" sometimes called a "drop test" on the batteries. they will ...
...car charger put back in drives and all works, holding charge check the fuse for the charger socket ? if you got a electronic meter chec kthe two outside pins of the charger socket ? can you see the ...
Question about Mobility Victory 3 Wheel Electric Scooter
can this scooter dismantle to put in the car most mobility scooters are too heavy to lift into a car as the batteries and motor weigh too much as a unit.
Question about Mobility Victory 3 Wheel Electric Scooter
...i want to know how it comes apart to put in the boot of a car seat and batteries lift off handle might fold down. ...
Question about Mobility Victory 3 Wheel Electric Scooter
...car charger on the one battery at a time to bring up the voltage a bit be sure the batteries are disconnected from the scooter first before trying this and only for a few min. Car chargers will fry ...
Question about Mobility Victory 3 Wheel Electric Scooter
battery in it? Make sure they are ONLY connected with a "+" to a "-". NEVER connect a "+" to a "+" or a "-" to a "-". This can sometimes make batteries explode if connected wrongly. Always put the RED
Usually answered in minutes!
356 Questions
246 Questions
187 Questions
140 Questions
159 Questions