Questions & Answers for: pulled stuck paper printer bits

...printer is only a month old. I was able to cut and insert a piece of dense foam on the left side of the upper paper tray which blocks the paper from tilting to the left when feeding. This seems to ...

...off and put a small bit of soft foam under it so it always got pushed back up. works a treat now. thx again check that there is no paper stuck in fusing unit, check that solenoid/sensor is moving ...

...stuck in fuser I had a paper jam and when I pulled the paper from the fuser, some pieces got stuck in the fuser. There's no way to reach them to get them out. What do I do? Pull fuser out Should be 2 ...

...pulled out. Well, the paper is tight and I can't pull it out. What can I loosen or do? You will have to pull hard and evenly to remove the paper. Often, the toner has built up on the fuser rollers, ...

...stuck on the rest position instead of jumping back when the solenoid is switched off. Result instead of workign the clutch to control the roller correctly, the roller goes into the wrong position and ...

paper passes over while the ink is being quirted) there is a strip of oddly cut sponge foam - and this foam as somehow come out of its seating and is getting in the way. Open the printer as if you are

...stuck inside the printer which restricting the printhead to move freely. To resolve this issue, please follow the instructions mentioned below: 1) Confirm that the printer is powered off. 2) ...

...pulled paper out but I have bits of paper still stuck and cannot reach them. How do I get it out? They are way in the back. I was printing and ran out of paper. I filled the paper tray and turned the ...

...paper is stuck somewhere in the paper feed route. Remove the toner cartridge and any other bits that pull out. Removable bits often have a green tag or finger grips moulded in to them. Do a careful ...

the paper tray. Remove the paper tray and inspect the place where the paper gets pulled into the printer. Sometimes you will find a sheet of paper stuck there that isn't readily apparent anywhere else