Question about Elite Rewind Bagless Upright VacuumVacuum
...cord pulled out, the rewind spring should be very tight. The mechanism may just need lubricating, or there is a worn or broken part preventing the spring from retracting the cord, or the spring is ...
Question about Elite Rewind Bagless Upright VacuumVacuum
...pull cord I have a cub cadet lawn mower pull cord that broke when replacing the cord the recoil assembly popped. do I just rewind the recoil and how do reset the rest of the assembly just rewind the ...
Question about Elite Rewind Bagless Upright VacuumVacuum
...cord. Engage the rewinder wheel with your fingers pull the screwdriver and wind the spring as tight as you can. Re-install the screw driver thru the wheel so it can not rewind and reinstall the cord. ...
pull cord MTD 3.5 HP 20'' lawn mower pull cord has disconected inside. How do I fix it? This works best with two people. Remove cover and pull cord will be inside cover. If your handle on pull cord is
Question about 22" Yard Machine Push Mower
pull cord broke on my craftsman gas push edger. I replaced cord but when I pull cord..It wont rewind but I can hear it trying to start It sounds like you did not properly rewind the spring that is ...
Question about 22" Yard Machine Push Mower
...Pull the cord out several times to make sure nothing interferes with cord and mechanism, then install on the saw and check the start operation. The spring should never bind-up when the cord is fully ...
pull cord won't rewind started mower and was mowing when noticed pull cord dangling, stopped and tried to get it to rewind and it stops because there is a little metal clap thing tight on the cord
Question about Personal Pace CARB Walk Power Mower
pull start cord won't rewind model no RLT30CET curved shaft electric start PULL CORD BROKE.I HAVE REPLACED THE CORD BUT I AM UNABLE TO REWIND THE CORD WHEN PULLED. IS THERE A SPRING THAT SHOULD BE
...pull cord Ariens Snowblower926LE Model #926007 Serial #001931 Broken pull cord...rewind assembly is riveted to housing. Do I have to drill out rivets to replace pull cord? No you remove the engine ...
Question about Pro Mac 605 610 645 650 655 92466
...pull cord for pm 605 mcculloch chainsaw? Pull cord broke. First remove the pull starter housing. The next part is tricky. You'll have to release and unwind the spring that rewinds the pull starter ...
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions