Pull cord on weedeater wont recoil I have a Stihl FS 55. The pull cord will not recoil. I took it apart and rewound the cord. It would pull 2 or 3 times with partial recoil each time until the cord ...
...pull cord jams. The cord moves only about two inches, then stops abruptly. i had the same thing with a stihl hedgecutter its a part in the centrefruge that locks if you pull to hard pull slow and let ...
Question about Complete Carburetor for Stihl 4122 Brush Cutter and 4226HS Hedge Trimmer
...pull the recoil rope more than 6-8 inches..needless to say the blower won't start.. Are you sure you have the right length rope??? If you are sure the rope length is correct you may have wound the ...
pull cord i roadworks63. Pull off the right side cover to expose the recoil, remove the rest of the rope. Now rewindthe pully c.c.wise until it stops then release it just enoughto align the rope holes
...pull the cord out of the hole and COMPRESS the spring. put the tab on the tail end into the housing, and put the white spool in the inner end of the spring. rotate the spool while keeping your finger ...
Question about Concrete Cutoff Saw Rewind Recoil Spring Ts 400
...cord will not retract after the first pull. The spring is still intacted but doesn't spring back when re-attached to weed eater. One of 2 things come 2 mind, if the spring is still in tact it ...
Question about Trimmer Oe Rewind Starter Spring 36 40 44 Fs36 Fs44 4130-195-1600
...recoil spring rewound, now the cord and spring are interlocked. I'm looking to strip the recoil mechanism but I believe I See above how to remove clutch Its an easy opperation to undertake if you ...
Question about Concrete Cutoff Saw Rewind Recoil Spring Ts 400
...pull cord hasn't snapped it just wont recoil! is this an easy fix? Sounds like the starter spring has broken, remove the three torx screws securing the starter and remove the starter, prise off ...
Question about Chain Saw Handle Models 044 046 Ms440 Ms460
pull cord is pulled out and saw is dead more information needed. You may have just broken the recoil spring in the pull start housing
Question about Chain Saw Handle Models 044 046 Ms440 Ms460
pull on the cord to see if it will work and that the cord returns back into the recoil automatically. Don't take the nut off the inside of recoil holding the cord spool on. If the engine is not seized
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions