Questions & Answers for: pt cruiser steering problems

...pt cruiser. I believe it is also draining the battery. I had the same problem. When I adjusted the height of the steering wheel (slightly violently, as I was super frustrated), it stopped. It happens ...

...PT cruiser? I need to replace the rack and pinion steering. Thanks! i don't know about free, that is quite a complicated process to replace the rack, pick up a repair manual at parts store, haynes is ...

...PT cruiser...power steering?? PO551 fault code on PT cruiser...power steering pressure switch. Engine light has now gone off, do I still replace or is it just acting up? i would check the power ...

...it be the pump already this is 04 pt cruiser 1st have you looked under the hood may be the belt thats lose or broke maybe low on power steering fluid.if all looks good then it may be a pump

...PT Cruiser? ALWAYS, ALWAYS, ALWAYS...CONSULT YOUR OWNERS MANUAL, FROM THE FACTORY! IF YOU DO NOT HAVE ONE, CALL OR VISIT A DEALERSHIP. AS A FORMER SERVICE MANAGER MYSELF, I HAD NO PROBLEM SHOWING ...

...PT Cruiser? Limited Edition First figure out if it's the horn or the switch. Go out and hit the panic button on your fob. Does the horn go off?OK, it's not the horn. Your problem is in the switch in ...

pt cruiser 2003 2.4 turbo code p0552 stalled while driving 25 mph P0552 CHRYSLER - Power Steering Pressure Sensor Circuit Low Input https://www.autocodes.com/p0552_chrysler.html P0552 - Power Steering

...pt cruiser shuts off while driving locks the wheels also. let rest for a minute and starts again happened twice over last 3 weeks The engine runs the power steering pump. When the engine dies, you ...

...PT Cruiser only engages when the engine is at or above 2500 rpms what are the possible problems? Low on Power Steering Fluid is my guess. It usually makes a noise when you turn the wheel at idle. If ...

...pt cruiser with key stuck in ignition and am still waiting for answer. I had the same problem with my 2003 PT . what i did was move the the steering wheel down a little using the tilt lever . I think ...