Questions & Answers for: pt cruiser crank position sensor

...pt cruiser near the oil filter.. above it...under exhaust manifold one small bolt holds it on. If the is a no start condition look for frayed wiring near crank sensor..... it has a harness that hangs ...

...PT Cruiser (2002) runs for 5 min., then stalls....5min. later it starts then quits again. P1391 code comes up. P1391(M)Intermittent Loss of CMP or CKPLoss of the Cam Position Sensor or Crank Position ...

pt cruiser went dead and now it crank but wont start check your crank position sensor. it might be bad. these also have a problem with the cam position sensors.

...pt has fire on 1and 4 and 2and3 dose not,even with new coil same problem? This tells me you have a bad Crank Position sensor or bad cam position sensor that is not sending the signal to fire those ...

my 2001 pt has fire on 1and 4 and 2and3 dose not,even with new coil same problem? This is a bad Crank Position sensor or a bad Cam Position sensor.

...PT Cruiser? It absolutely is not above the oil filter as on 01-03 PT's. REMOVAL - 2.0, 2.4, 2.4L TURBO The Crankshaft Position Sensor is in the front of the engine block just under the starter ...

...PT Cruiser when I start it and drive for about 15min it would just cuts out and wont restart, do anyone know what's causing the problem. Thanks Reggie. does it start back up ater it cool down? crank ...

...PT Cruiser no crank Drove into garage, running fine. Next day no start. Cranked fine. I got back home today it cranked about 10 revolutions and no crank. Getting power to the ignition switch, I can ...

pt cruiser has been in the shop multiple times.bringing up code P1391 & P0352. It bucks hard engine light comes on it stalls out. what can it be?I work out of homes and need to transport. 3 cam sensor

pt cruiser starts ,runs for 15 mins shuts off wont start for maybe an hour then does same thing Ignition control module (ICM) or also maybe the crank position sensor. If one of them went bad, it would