Zenith TV B32A24Z No Picture no sound, you do hear it power up but that is it. I'd appreciate any help. Thanks Dave You have a power supply problem. On this set the entire board is available for ...
...mode. Try first leaving the TV power cord unplugged for some times, let say one hour or so. Also ensure that the fault is not coming from a faulty receiver box sending bad signal, check if you get ...
...system is going into the protection mode to further prevent it from damaging the circuits.The only solution is to get it repaired by a technician. Goodluck, Please don't forget to rate the
dvd freezes during play Intermittently, the picture in play mode will freeze and not continue on its own. Does this happen with all the DVD's or just one particular movie ? 1) If the problem happens ...
...mode. Try first leaving the TV power cord unplugged for some times, let say one hour or so. Also ensure that the fault is not coming from a faulty receiver box sending bad signal, check if you get ...
...something in the power supply module has failed and the unit then goes into protection mode to protect the board components. Your surround sound need service from a qualified tech. No other
Question about DVT412 System
...protection mode after 15 minutes no sound Disconnect your speakers when unit off and cold. Turn unit on and wait. If unit stays on, check speaker wiring for damage. Connect one speaker at a time with ...
Usually answered in minutes!
269 Questions
273 Questions
232 Questions
195 Questions
159 Questions